im looking for everything to swap a 5 speed into my 88 iroc. i already have the pedals, but thats about it. thanks

 

location?

 

yep, location would help

I have a T5 sitting here if you're interested

-jason

 

louisville, ky

 

I have a stock shifter with ****. $25 shipped.

 

I have a lakewood belhousing and the bolts with the plate. Had to do a little bit of grinding on it for header clearance but it works and still looks good for $300
I have a pedal assymbly with the switches for $75
I have a manual linkage bellhousing for $75
I have a stock camaro bellhousing for hydralic v8 camaro for $100
I have a zoom clutch setup 11 inch used but not much $75
I have the stock shifter plate in perfect condition for $90
I have a b and m ripper shifter for $115
I have slave and master cylinder setup for $90
I have a 168 tooth flywheel for a one piece rear main that has been zero balanced for my 383 stroker for $75
If ya need anything just e-mail me at peanutmrpeanut@aol.com or repost. Thanks

 

i have a hydraulic set up from pedal to linkage.that connects to the bellhousing ..70 shipped..going to a auto in my car

 

I have a almost new (1000 miles on it) Hayes 153 tooth (Billet Steel) Flywheel for SBC w/ 1 pc Rear main seal. I am asking $175 B/O for it.

 

I have a great condition T5 that was just gone through by a transmission specialist at a transmission shop. I was having it rebuilt for my car, but I sold the car before it was installed. I had it completely taken apart, cleaned, and reassembled with any new parts that were needed (new input shaft).
I would take 450 for this perfect T5 Transmission if you are interested.
Call me on my cell phone of 606-620-2723

 

I have a 168tooth flywheel new in box. Billitt steel $90 shipped to your door.