Long shot but looking for a good set of super ram runners only

 

Geez, Brian. You're not asking for much! Ha ha.... I actually scored a set a few years ago. I purchased the pizza box plenum off of ebay. I already had a TPIS Big Mouth (which you somehow ended up with later on). I posted just as you have and a set turned up. I sold them last year. I would love to have them back. I work in a full up fabrication shop and I always wanted to do a set in stainless steel using thin stainless mandrel bent tubing.

 

I know bill, it might be a hard find, I have a new old stock plenum and lid but no runners would like to complete that sr. I did run a cross a t-ram a while back Im close to having it all cleaned up

 

found

 

Unbelievable! There has got to be a good story behind that.....

 

I took a sr in to be powder coated, went to pick it up and the runners were no were to be found. they said I never brought them in. I actually just sold that intake that use to be yours to help with the purchase of the runners. Finally I will have a complete sr
I purchased a nos sr awhile back robbed the runners from it so these will go with my new plenum and lid.

https://www.thirdgen.org/forums/engi...am-intake.html

 

So did the powder coater lose or steal the runners? I once took in a rare 1966 El Camino rear bumper to be plated. This was before re-pops so these were very difficult to find. When I came to pick up the bumper, the plater told me the bumper was stolen and offered to make it good. He offered $500 but that wouldn't get me another bumper. I was furious. When I looked out the side window of the office, two guys were loading my bumper in their truck. The plater needed the bumper for his project and made up the whole story!!

 

they would not admit to stealing them witch they either stole them or lost them. I got these polished runners for $400 witch was just a little more than I wanted to pay but what good is the sr with out them. I have lost faith in taking parts anywhere I have had bad luck a machine shops when I lived in Idaho jacking up a engine and messing up a set of axles I had turned down for disc brakes. Told the the specs for the arp holes .005 press fit . I could remove some of the studs with my hands they were wobbly . there response was they will tighten up you bolt on your wheel wtf. over made me a perfect set to my specs. I can't believe some crooks.

 

I picked up a set of superram runners by themself too... I scored them for $125 shipped, but the holes were threaded for the plenum to bolt on from the top. Which is perfect because my old plenum had a few stripped threads which is why I purchased a NOS plenum as well... lol

The guy bought his car with them, but didn't have the plenum, and wanted them gone. They were painted red though, so I still need to strip them.

 

You got a deal on the runner, My buddy Andrew didnt know there value