Hey all, looking for a good set of 8 stock 5.0 TPI Injectors for my 89 Formula. These would be the Multec ones w/16.0+ ohms. Not sure of the original part number but think the rated flow is 19 lbs/hr. As I recall the 89-92 5.0 TPIs used the same injectors. Can pay w Pay Pal...

 

I have a set of 19 lb injectors off a 89 Camaro 5.0 if your interested

 

PM reply sent.

 

Still lookin'! Anyone??

 

$65 Shipped,.......... ( Need to be painted ! )



$80 Shipped,.......... ( Should be painted ! )



Both sets are 305ci, 19lb injectors. I had them hooked to a switch and heard each one "click" as I pushed the button and released. They were also OHM tested before I cleaned them up. I don't install used injectors myself without installing new filters and O-rings....... I recomend it with these too. Flow testing not a bad idea either.

Send me a PM if your seriously interested.

 

I have these that I bought new a few years ago from WS6project. 82-02 V8 Ford Racing SVO Fuel Injectors (19lbs/hr)
I swapped motors 2 years ago so they have not been used that long. Probably only a couple hundred miles on them. They are like new

 

John in RI and Pop6482 - thanks for the replys and offers, but I'm looking for the GM/AC Delco Multec Style injectors. Those Bosch style ones might work fine but I feel better about getting the right ones like came original on the engine. I've got to get the old Bird through WA emissions one last time before it's a "Classic" and no longer subjected to regular testing...

 

iroclbz - if you still have those injectors and TPI stuff I'm still interested - haven't heard back from PMs sent to you so trying a reply here...

Otherwise folks, still looking for some GM/AC Delco Multec Injectors for my 5.0/305 89 Formula...

 

I have a factory set from an 87 iroc if interested.