Looking for the silver metal air tube that goes from the air diverter valve to the catalytic converter in good condition for a single cat setup. Hopefully with how many people ditch the emissions someone has a nice one left around .

 

You can get this from Summit a Racing. They also have the weld version

https://www.summitracing.com/parts/wlk-35574

 

Good to know that's available. If someone has the stock pre-bent line with the threaded end I'd prefer that though just for ease of installation/stock appearance.

 

TTT, someone's gotta have a stock piece.

 

Let me see if the one that came off my friends car is still on the parts attic.

 

If Quickchicken does not have one PM me I may

 

is this your critter?

 

That looks about right. I can gently massage it into shape if it's a little off, but it should work much better than my crushed/broken one. How much shipped to 80521?

 

Let me find a box and get an est. I can probably have you a quote min if that's ok?

 

Not familiar with the term quote min? Probably something really obvious...

 

I'll find out shipping cost by mon.

 

Sounds good, thanks.

 

I haven't forgotten about ya, still looking for a box. If I don't find one shortly I may make one.

 

Any updates?

 

Yes!! I have a box and I just had to tweek the tube a tad. I wanted to find a box that would help avoid me having to bend on it and this one is the best I found. Send me a zip and I'll get a quote. I'll most likely get my wife to ship it USPS as fed and ups are higher than a giraffes ***.

I just went back and looked, you sent a zip.

 

I am also looking for the same pipes. Anyone else have extra one. Or can I use small steel pipes from home Depot or lowes. Ppl who work on my engine and tranny couple years ago left a 6 inch gap between pipe and cat.