Engine swap-Parts swap?
Thread Starter
Junior Member
Joined: Jun 2002
Posts: 43
Likes: 0
From: North Coventry, Pa
Car: 1984 Trans Am
Engine: L98 350
Transmission: 700R4
Engine swap-Parts swap?
I own an 84 TA LG4 305. I'm switching to a '92 L98 350. I was wondering if the following is interchangable between blocks:
1) Vibration Damper
I know the flywheel is different, but will the torque converter from the 84 bold up to the flywheel of a 92?
Finally, will anything else from the back of the block change between 84 and 92, (ie: tranny hook up parts)?
Thanks for any replies.
1) Vibration Damper
I know the flywheel is different, but will the torque converter from the 84 bold up to the flywheel of a 92?
Finally, will anything else from the back of the block change between 84 and 92, (ie: tranny hook up parts)?
Thanks for any replies.
Joined: Mar 2000
Posts: 43,187
Likes: 43
From: Littleton, CO USA
Car: 82 Berlinetta/57 Bel Air
Engine: L92/LQ4 (both w/4" stroke)
Transmission: 4L80E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
The number of splines on the tranny input shaft doesn't have anything to do with the flexplate bolt pattern. Your torque converter will bolt up to the '92 flexplate.
As will everything else. Except the damper is different, use the proper 350 piece.
As will everything else. Except the damper is different, use the proper 350 piece.
Thread
Thread Starter
Forum
Replies
Last Post