Engine Wiring Harness Removal
Thread Starter
Member
iTrader: (2)
Joined: Jul 2010
Posts: 399
Likes: 2
From: Victoria, BC
Car: 89 Firebird Formula
Engine: 3500T
Transmission: T56
Axle/Gears: 9 bolt/4.11
Engine Wiring Harness Removal
Hi. I've gotten all of the engine wiring harness removed except I can't figure out how to disconnect it where it goes through the firewall on the driver's side. There's a photo of it attached
Joined: Mar 2000
Posts: 43,187
Likes: 42
From: Littleton, CO USA
Car: 82 Berlinetta/57 Bel Air
Engine: L92/LQ4 (both w/4" stroke)
Transmission: 4L80E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
And the bolt doesn't come out - you have to loosen the bolt and gradually pull back on the connector until both disengage.
At least that's what mine did...
At least that's what mine did...
Thread Starter
Member
iTrader: (2)
Joined: Jul 2010
Posts: 399
Likes: 2
From: Victoria, BC
Car: 89 Firebird Formula
Engine: 3500T
Transmission: T56
Axle/Gears: 9 bolt/4.11
Re: Engine Wiring Harness Removal
Thanks so much for your help. Once I knew where the bolt was it was simple. I'm installing an LT1 and I've sold this wiring harness with the old engine.
Thread
Thread Starter
Forum
Replies
Last Post
