EGR from AIR tubes
#1
Senior Member
Thread Starter
Join Date: Nov 2002
Location: Orange County, CA
Posts: 645
Likes: 0
Received 1 Like
on
1 Post
Car: 86 TA
Engine: 305 TPI
Transmission: 700R4 - 2200 stall
Axle/Gears: 3.42 posi
EGR from AIR tubes
Question: Could the EGR be tapped off from the AIR tubes?
I'm looking at doing a 350 swap, but want to know if I can do a corvette style EGR tube (using a corvette base or even engine), and run a EGR tube from intake base over to the AIR system and tap off the same port which is already on the header instead of welding a new port to the headers. The headers plan to use are the ceramic coated hooker 2055's. I'm not sure why folks would weld a new tube on the header when this connection point is already available, unless it would screw with the AIR system.
I'm looking at doing a 350 swap, but want to know if I can do a corvette style EGR tube (using a corvette base or even engine), and run a EGR tube from intake base over to the AIR system and tap off the same port which is already on the header instead of welding a new port to the headers. The headers plan to use are the ceramic coated hooker 2055's. I'm not sure why folks would weld a new tube on the header when this connection point is already available, unless it would screw with the AIR system.
Thread
Thread Starter
Forum
Replies
Last Post
CamaroX84
Tech / General Engine
1
06-11-2001 09:46 AM