Using oem serpentine setup with double hump heads
Thread Starter
Junior Member
Joined: Jul 2025
Posts: 1
Likes: 0
Using oem serpentine setup with double hump heads
Hey everyone. I have an 88 gta. Im swapping out the locked up tune port that was in it for a 355 with a carb ive built. Im going to be using a set of 186 double hump heads that have holes for accessories. Am I going to run into any issues when trying to reuse the original serpentine setup including the ac? Any input is appreciated thanks
Joined: Sep 2005
Posts: 27,918
Likes: 2,448
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
Re: Using oem serpentine setup with double hump heads
Nope. AFAIK all the holes you need are there, with one possible exception, which if you need it, you can drill & tap it.
Thread
Thread Starter
Forum
Replies
Last Post
66_C10_TPI
Tech / General Engine
2
Aug 29, 2003 11:35 PM
