ok i have open headers(headman longtubes)right now and its too loud (488 510) cam and you can hear my car blocks away its annoying now hears my dilema i need exaust option 1 have a exaust shop fab a y pipe then run in stock location with 80 series option 2 i will buy some hedman x tensions and run true duels o 40 series have to take a hammer to floorpans run to exaust shop to get mufflers welded to pipes etc option 3 run spintech oval exaust true duals dumped. i would like to someday lower the car and i will defintally be putting subrames on it gear swap etc what do you guys think? thanks chris

 

there is a good thread in this section about oval exhaust on a lowered vehicle. it has pics. looks real good with lots of clearance. also looks like it wont be cheap. i myself am going to try the car chemistry collector inserts

 

what does the car sound like with headers and collecter inserts does it sound good or is it still extremely loud?

 

any way you can get a sound clip of the long tubes on there i was planning on getting those and runnin em

 

it is extremely loud the recorder doesnt pick it up it echoes off EVERTHING houses mailboxes everything at idle you can hear it atleast 2 blocks away it sucks goinging up hill people yell at me cant drive anywhere at night sets off car alarms it sucks it sounds good the first day but after that plain and simple annoying

 

Trax is running deep into the 11's with single 3" through an ultra flow Dynomax in the stock location. According to Dynomax's website the formula for exhaust CFM needed to support your HP is HPx2.2=CFM needed to support your engine without hindering horsepower output. I am probably switching back to single 3" from dual 3" because I want to lower my car more.

 

i think ill have a y pipe fabbed then run it in the stock location with either a 80 series or hooker aroe chamber 3in because im getting ready to lower the car.