Catback system without cat??
Thread Starter
Supreme Member
iTrader: (4)
Joined: Oct 1999
Posts: 4,211
Likes: 3
From: GO PACK GO
Car: 83Z28 HO
Engine: Magnacharged Dart Little M 408
Transmission: G Force 5 speed
Axle/Gears: Moser 9" w/Detroit Trutrac
Catback system without cat??
I hope this doesn't sound too stupid, but I am looking into running 3" pipe to replace the cat on a Hooker catback system. Is the muffler tuned to take backpressure from the cat?
I assume I should see a small gain from this since it's a 400 and I think I'm choking it a little. Will it get a lot louder or stay the same? -
Oh, and if I had emissions to worry about, I would'nt have asked this...
I assume I should see a small gain from this since it's a 400 and I think I'm choking it a little. Will it get a lot louder or stay the same? -
Oh, and if I had emissions to worry about, I would'nt have asked this...
Supreme Member
Joined: May 2003
Posts: 1,995
Likes: 0
From: Toledo, OH
Car: 1992 Firebird
Engine: forged 357
Transmission: 700r4, 2200-2400 stall, vette servo
Axle/Gears: stock pegleg 2.73 drum (temp)
yes it will be louder, probably significantly louder due to the fact you have a 400. you're not hurting anything.
Joined: Mar 2000
Posts: 43,187
Likes: 45
From: Littleton, CO USA
Car: 82 Berlinetta/57 Bel Air
Engine: L92/LQ4 (both w/4" stroke)
Transmission: 4L80E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
I haven't tried it (yet), but a Dynomax Bullet in place of the cat would have the effect, I'd think, of mellowing out the exhaust tone a little w/o introducing significant flow restriction.
Thread
Thread Starter
Forum
Replies
Last Post
