copper header gaskets
Thread Starter
Junior Member
Joined: May 2005
Posts: 69
Likes: 0
From: southern calif.
Car: 91z28vert,3:42posi-rear,gu6
Engine: 305TPI
Transmission: T-5,pro5.0 shifter
copper header gaskets
does anyone know which way a set of copper gaskets should be installed?one side has raised edges,and the other side is indented,if your looking at the raised side is that how they are slid in?with the raised side of the gasket facing out,i never used these before and dont know which side faces out when sliding them down in between the header flange and exhaust ports,does any one know which side faces out the raised or the indented side? this sucks not knowing for sure,iam guessing the side with the markings on them should face out right?they are stamped with part# on raised side,but not sure
Member
iTrader: (2)
Joined: Sep 1999
Posts: 351
Likes: 0
From: Palos Hills, IL USA
Car: 1992 25th Anniversary Z28
Engine: 6.3L - 383
Transmission: 700R4; Vig 3200
Usually the gaskets themselves will say on them "this side out", but on my SCE gaskets the raised section is out touching the header flange.
- Joel
- Joel
TGO Supporter
Joined: Oct 2002
Posts: 9,067
Likes: 1
From: Saskatoon, SK, Canada
Car: '83 Z28, '07 Charger SRT8
Engine: 454ci, 6.1 Hemi
Transmission: TH350, A5
Axle/Gears: 2.73 posi, 3.06 posi
Originally posted by MrDude_1
flat side to head, embossed side to header.
flat side to head, embossed side to header.
Thread
Thread Starter
Forum
Replies
Last Post
Chad Speier
Engine/Drivetrain/Suspension Parts for Sale
3
Sep 24, 2015 12:32 PM
