So I got the hooker 2055 headers and y pipe, my original plan was 3" cat to 3" cat back flowmaster system...

But what about this:

Id like to run a 3" electric cut out before the cat, now iv been told that if I go that route it will just sound terrible when the cutout is open, kinda like a truck...

But is there room for me to run a cutout with a cherry bomb glasspack along side to about under the rear seats.




obviosuly pictured is the nasty rusted shitty stock exhaust that is being replaced


I figure there might be room tucked under the passanger side. Anyone done anything like that before?

 

also too, are you guys cutting back the y pipe a little bit so that when the cutout is installed the pipe is still the same length as when its just the y pipe?

figured id ask b4 i chop up my hooker 2055's