I am in need of some pics of rear bulkhead's done in thirdgen's.
My chasis guy want's me to dig up some pictures but I have been searching for hours, and have only found 1 pic... and it was a fourth gen.
Please, if you can help a fellow member out post your pics here.
DonB.

 

Thanks for all your help.

 

What do you mean by bulkhead?

 

A rear "firewall" Intended to section off the fuel cell & battery from the drivers compartment.

 

Here are a few but not any good ones. Of course this is a back half car.

http://photobucket.com/albums/v739/red91z/

 

Thanks, I'll print some of those and see if we can use them for ideas. Thanks for the help, it is much appreciated!

 

Just seen this thread now. Here's a couple of pics of mine.

A construction pic. Note how mine has a hinged horizontal lid, to allow complete access to the "trunk" area. There is also a vertical lip on the rear edge that closely follows the inside contour of the rear hatch glass. A piece of old rear hatch weatherstripping is used as a seal. Framework for the lid was done in 3/4" aluminum, and riveted in place.



Here's a completed pic.

 

Thanks for the pics, That's exactly what we were looking for!
I'll post pics when we are done for future reference for board members.
DonB.