Split rear seat?
Thread Starter
Senior Member
Joined: Apr 2006
Posts: 836
Likes: 0
From: Pgh PA
Car: 89 5.7 IROC/95 LT1 Corvette
Engine: All 5.7's
Transmission: 700R4 (Roessler)/ZF6
Axle/Gears: 10 bolt Zexel 3.23's. CTW 17" wheel
Split rear seat?
Does anyone know if these will just bolt up in place of a solid rear seat back or do I need extra brackets or something? Thanks!
Last edited by Eagle223usa; Jul 2, 2008 at 02:03 AM. Reason: Spelling!
Senior Member
iTrader: (6)
Joined: Mar 2007
Posts: 272
Likes: 0
From: New Hampshire
Car: 1991 RS Hardtop
Engine: 305 TPI
Transmission: 700R4
Axle/Gears: 3:23
Re: Split rear seat?
You will need to get the bracket that goes in the center of the seats. It is welded in, but you can cut it out of the donor car, and bolt it into yours. You will probably also need the release handle and bracket on the drivers side, as well as a new piece of interior trim. My car had it installed already, but I remember people telling me that many cars did not... hope that helps
Thread Starter
Senior Member
Joined: Apr 2006
Posts: 836
Likes: 0
From: Pgh PA
Car: 89 5.7 IROC/95 LT1 Corvette
Engine: All 5.7's
Transmission: 700R4 (Roessler)/ZF6
Axle/Gears: 10 bolt Zexel 3.23's. CTW 17" wheel
Re: Split rear seat?
Copy that, Thanks. All I can find in repopped seat apolstery is for split rears. I'd like to keep my solid rear but cannot find covers. Thanks again!
Senior Member
iTrader: (6)
Joined: Mar 2007
Posts: 272
Likes: 0
From: New Hampshire
Car: 1991 RS Hardtop
Engine: 305 TPI
Transmission: 700R4
Axle/Gears: 3:23
Thread Starter
Senior Member
Joined: Apr 2006
Posts: 836
Likes: 0
From: Pgh PA
Car: 89 5.7 IROC/95 LT1 Corvette
Engine: All 5.7's
Transmission: 700R4 (Roessler)/ZF6
Axle/Gears: 10 bolt Zexel 3.23's. CTW 17" wheel
Re: Split rear seat?
Looking for tan custom cloth 1989 in I guess it's called sandstone. Thanks. The idea is to have them all match!
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
May 10, 2023 07:19 PM
