Not sure what to call it but what is the part the e brake handle goes through?
I was cleaning up my console to re-install and realized I don’t have it. Not sure if I ever had it for this car.
I remember it being attached to the console plate and being kind of a strip of rubber with a slit in it from my other third gens.
anyone got a pic? Where to buy? How to attach?

 

You would probably have to buy an entirely new upper console. IIRC from when I had a Camaro it was just basically a piece of rubber with a slit sandwiched under a second piece of plastic that was glued in place. Should be pretty easy to fabricate from a strip of rubber or automotive vinyl.

 

I redid mine and used those short torx screws used in our interiors to hold it in place.Normally there's a plastic rivet there, but you have to break it to remove/replace the flap.

 

The rubber and retainer are missing on mine. I think I can fav something up though after looking at it closer.
thanks for the replies