Has anyone heard of this setup, and....
Thread Starter
Junior Member
Joined: Jul 2006
Posts: 30
Likes: 0
Has anyone heard of this setup, and....
hey i just found this set up ( http://silveradosupersport.com/untitled1.html ) and was wonder if it was a good alternative to using the ls1 harness and computer, just let me know what you guys think, i dont even think this is out yet but any opinions would be appreciated!
Joined: May 2004
Posts: 1,037
Likes: 2
From: Kingsport Tenn
Car: 1992 camaro
Engine: LT1
Transmission: 4L60E
Axle/Gears: 3:73
Re: Has anyone heard of this setup, and....
It may just be me but I dont think edelbrock lives up to its hype. Buy mabey I'm wrong on this.
Supreme Member
iTrader: (1)
Joined: Aug 1999
Posts: 1,387
Likes: 0
From: Northern NJ
Car: 89 Formula / 09 G8
Engine: LS1 / LS3
Transmission: M6 / M6
Axle/Gears: 3:42 / 3:27
Re: Has anyone heard of this setup, and....
Why bother?
Not that a SBC is a bad engine for its' time by any means but why not step into; girdled block, coil on plug ignition and all the other new age goodies
Not that a SBC is a bad engine for its' time by any means but why not step into; girdled block, coil on plug ignition and all the other new age goodies
Member
iTrader: (4)
Joined: May 2003
Posts: 118
Likes: 1
From: Marine City, MI
Car: 91 Z28
Engine: 6.0 LSX Single turbo
Transmission: 4l80E
Axle/Gears: Moser 9" 3.55
Re: Has anyone heard of this setup, and....
how can they consider that (ls1 based) just because it has lsx throttle body? looks similar to a ram jet to me.
Senior Member
iTrader: (1)
Joined: Nov 2002
Posts: 889
Likes: 0
From: Kansas City
Car: 1991 Trans Am
Engine: L98
Transmission: T56
Re: Has anyone heard of this setup, and....
The only thing LS1 related about that intake is that it uses a 90mm LS1 based throttle body. That intake is made for a Gen 1 SBC.
Thread
Thread Starter
Forum
Replies
Last Post