LSX/4L60E swap Shift Linkage?
Thread Starter
Senior Member
Joined: Aug 2006
Posts: 807
Likes: 2
From: Ontario, Canada
Car: 1991 Trans Am GTA
Engine: LSX (swapping)
Transmission: 4L60E (swapping)
Axle/Gears: 2.73 Posi 10 Bolt
LSX/4L60E swap Shift Linkage?
What should I do to get the linkage to work on my 4l60e? I have the original shift linkage from the 700R4. Can the 4th gen linkage be used or is there a way to use the 700r4 linkage with the 4l60e? (Trans has a male screw type connector, as does the linkage) Male on male.
Junior Member
Joined: Jan 2007
Posts: 4
Likes: 0
From: Cincinnati, OH
Car: 88 Trans Am
Engine: 98 LS1 TQRv2 Loudmouth
Transmission: GTO T56 & MGW shifter
Axle/Gears: 8.8 from a ranger with LS1 Tubes
Re: LSX/4L60E swap Shift Linkage?
Just use the shift arm off the 700r and the linkage bolts on. The 700r uses the same pan as a 4L60E.
Re: LSX/4L60E swap Shift Linkage?
Get one from a JY or trans shop. The 700R4 cable fits fine, just move the bracket one bolt forward
I would suggest attaching the cable end to the inside of the arm for maximum exhaust clearance. It's going to be tight in there
I would suggest attaching the cable end to the inside of the arm for maximum exhaust clearance. It's going to be tight in there
Junior Member
Joined: Jan 2007
Posts: 4
Likes: 0
From: Cincinnati, OH
Car: 88 Trans Am
Engine: 98 LS1 TQRv2 Loudmouth
Transmission: GTO T56 & MGW shifter
Axle/Gears: 8.8 from a ranger with LS1 Tubes
Re: LSX/4L60E swap Shift Linkage?
I have an extra shift arm, PM me your address and I'll mail it to ya.
Thread
Thread Starter
Forum
Replies
Last Post
dhonda200
Transmissions and Drivetrain
6
Aug 11, 2015 11:50 PM
