I need a measurement please
Thread Starter
Junior Member
Joined: Jul 2009
Posts: 53
Likes: 0
From: Clovis, Ca
Car: 82 Z-28 (Cert 8.50)
Engine: 416 LS3 / 1050cfm
Transmission: Powerglide w/brake
Axle/Gears: 9" 4.86, 4-link
I need a measurement please
Anyone who has a LSx the stock location,( yes I know a LSx was never stock in a 3rdGen, but if it was...) I need the to know the distance from the square machined pad just under the cylinder head on the block to the frame rails. Both sides and front and rear if you can
Thread Starter
Junior Member
Joined: Jul 2009
Posts: 53
Likes: 0
From: Clovis, Ca
Car: 82 Z-28 (Cert 8.50)
Engine: 416 LS3 / 1050cfm
Transmission: Powerglide w/brake
Axle/Gears: 9" 4.86, 4-link
Re: I need a measurement please
Mine shows 5" on the passenger and 7" on the drivers side....is that what your getting?
Re: I need a measurement please
Stock K, spohn stands poly mounts
DF 7" DR cant reach
PF 5 5/8" PR 5"
Spohn K, Spohn stands, solid mounts
DF 6 3/4" DR cant reach
PF 5 7/8" PR 5 1/4
DF 7" DR cant reach
PF 5 5/8" PR 5"
Spohn K, Spohn stands, solid mounts
DF 6 3/4" DR cant reach
PF 5 7/8" PR 5 1/4
Thread Starter
Junior Member
Joined: Jul 2009
Posts: 53
Likes: 0
From: Clovis, Ca
Car: 82 Z-28 (Cert 8.50)
Engine: 416 LS3 / 1050cfm
Transmission: Powerglide w/brake
Axle/Gears: 9" 4.86, 4-link
Re: I need a measurement please
Pocket, your the man....exactly what I was looking for......Thanx!
Thread
Thread Starter
Forum
Replies
Last Post
Elephantismo
Electronics
14
Feb 13, 2019 12:51 AM