What ring gap should I run with 6-8psi boost?
TGO Supporter
Joined: Aug 1999
Posts: 14,811
Likes: 1
From: Jackson County
the standard rule of thumb is about .003 for every inch of bore. i look at the manual and usually split the high low. if you do anything that generates more heat you'll want wider gaps on the top ring to keep the ends from butting up. you also want a tight gap to prevent excessive blow by.
------------------
-=ICON MOTORSPORTS=-
1st & 3rd
------------------
-=ICON MOTORSPORTS=-
1st & 3rd
Thread
Thread Starter
Forum
Replies
Last Post
