I need the trim piece that mounts to the t-top and covers the outside edge of the glass (drip edge/rail?) You can see the piece I'm talking about in the picture. Mine is falling off and just plain screwed-up. Is this still available? I borrowed the pic from 'frenchians' thread.....

 

i have the same problem... mine is hanging, ripped and missing a chunk. ive been looking for that piece for a while and havent come up with anything.... hopefully someone else on here can help us out

 

can this piece be removed from one t top to another? ive got the same problem but ive got a spare set of t tops i could borrow from.

 

We all have the same problem. What would happen if we remove it altogther?

 

I may take that route and remove it.....
gmpartsdirect.com shows what looks to be a replacement piece but the diagram they show is not very clear.

 

do you have the page address i couldnt find anything on that site... i may be the guinea pig to see if thats the part or not. i imagine that if its removed its just another place to let water in so I'd like to get a replacement.

 

anyone taken these off before? how hard is it to switch the strip from one top to another?

 

I removed mine and so far no problem. I'm in So. Calif. though and there hasn't been much rain this year. There might be a little bit more wind noise but i listen to my music loud so not real sure.

 

Not cheap, but I think this is what you seek:

T-Tops Weatherstrip

 

no no, already have the weatherstrip.. just need the little piece that hangs over the door.

 

I just bought a set from gmpartsdirect.com,

Part numbers are;
Side Rail Seal RH 10198352
Side Rail Seal LH 10198353

The original ones are a firm rubber, the new replacement ones from GM are plastic. You can take the trim off the top and replace it but it’s a pain, at least mine where.

 

did they come with red tape on them? the seal kit i have has 2 plastic pieces that look about that size... didnt put 1 and 1 together

 

Yes, the red strip is on the double sided foam tape. It gets pealed off before installation so the foam strip will adhere to the T-Top and form a seal.

 

Ahhh now i get it.. its all so clear

 

thanks wildjeff...........just what I was looking for......
so, how big of a pain was it to replace these pieces?

 

You can also get them from fbody motorsports I think they were 49.00 each. I orderd 2 about 6 months ago they were a rubber plastic mix to replace the orignal they seem to work better. Heres a link to Strips. GM T-top Seal Retainer Strip http://www.fbodymotorsports.com/inc/sdetail/2212 if you call them and describe that part they can do it over the phone.

 

Do any of you who replaced the strips have a pic of what the new replacement ones look like?

 

I would like to see this too, the pic of the one for sale couldn't get any smaller.

 

I replace the trim and weather stripping on an 93 I had. not too dificult as I recall. got mine from Year One. I think it was made by Soft Seal?