Anyone ever broke Skulte 2" adapters?
Thread Starter
Junior Member
Joined: May 2003
Posts: 22
Likes: 0
Anyone ever broke Skulte 2" adapters?
I just installed a set of their adapters on my front end and I just don't have full confidence in them yet. I was wondering if anyone had ever had a set break, or does everyone like theirs? I need some responces to ease my mind.
TGO Supporter
iTrader: (1)
Joined: May 2002
Posts: 2,480
Likes: 2
From: El Paso, Texas
Car: 1987 IROC Z
Engine: 350 TPI L98 block
Transmission: 700R4
I run my IROC pretty hard with no difficulty... Andris runs a twin turbo on his camaro with his spacers... i'd have confidence in him.
[
[
Supreme Member
Joined: Mar 2001
Posts: 6,577
Likes: 0
From: Portland, OR www.cascadecrew.org
Car: 1990 Camaro RS
Engine: Juiced 5.0 TBI - 300rwhp
Transmission: T5
Axle/Gears: 3.42 Eaton Posi, 10 Bolt
the adaptors are pretty beefy, and they way they bolt on i would not worry, i would bet you break and axle flange or break a wheel stud first.
Member
Joined: Jul 1999
Posts: 373
Likes: 1
From: State College, PA
Car: '89 Formula
Engine: 383 Megasquirt
Transmission: T-56
Axle/Gears: 7.625
I have not broke mine. I road race and autocross on them and have had no problems.
Last edited by Colt; Jun 11, 2003 at 11:17 PM.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Pac J
Tech / General Engine
3
May 17, 2020 10:44 AM
sjorgens
Suspension and Chassis
7
Oct 1, 2015 07:54 PM
