best spring and shock combo for auto x
Thread Starter
Junior Member
Joined: Dec 2007
Posts: 96
Likes: 0
From: maryland
Car: 86 bird
Engine: LG4
Transmission: A4
Axle/Gears: 2.73
best spring and shock combo for auto x
i want to know what setups you auto x guys are useing on your thirdgens and other suspenison parts like strut bars sfc's ect. i am looking to get into auto x and want some 1st hand knowledge
Joined: Aug 2006
Posts: 12,804
Likes: 103
From: Central NJ
Car: 86 Trans Am
Engine: 408 stroker sbc
Transmission: TKO600
Axle/Gears: Moser full floater m9, 3:70 trutrac
Re: best spring and shock combo for auto x
figure out what class you want to run in, then get the rules for that class and see what you can actually do. No point buying a pile of parts if they will make you illegal.
Supreme Member
iTrader: (5)
Joined: Aug 2007
Posts: 1,525
Likes: 1
From: Milwaukee, Wisconsin
Car: 1987 IROC-Z
Engine: 383 with Edelbrock ProFlow EFI
Transmission: TH350
Axle/Gears: 12 bolt 3.73 Eaton posi
Re: best spring and shock combo for auto x
As long as you don't switch to a coil-over setup, most shocks are allowed in any class. My Konis can be used in the SCCA stock class, but my springs can't. Springs on the other hand are way different. If it isn't a direct stock replacement it won't be allowed in the stock class. Any lowering springs or stiffer then stock springs will bump you up.
Are you going to be running with the SCCA?
Are you going to be running with the SCCA?
Thread
Thread Starter
Forum
Replies
Last Post
