Well i have already taken apart all of the front linkage and im ready to go back in with the new parts....my question is how far do the parts excluding the ball joints need to pressed...i have a ball joint press that will do the job thanks for the help

 

What parts in particular are you referring to? The only other parts that need pressing are the a-arm bushings. All other stuff is bolted up. Just make sure you use the correct torque specs.

 

ok thanks i was talking about the tie rods ends, idler arm and center link..do you happen to know the torque specs or where they can found

 

Just did mine. LMK if you still need the info I have an 88 Firebird service manual with the info. Note the tie rod clamps have to be pinched tight in a certain way with the clamp openings away from the sleeve openings. Compare to what you took off.

 

thx talltim, torque info would be greatly appreciated:ball joints, inner/outer tie rod ends,idler arm pitman arm,sleeve clamps and sway bar end links

 

Since the pitman arm is a non-wear item, there's no need to replace it--unless, of course, it's been damaged. Aside from a bone yard, you probably couldn't lay hands on one anyway.

JamesC

 

ya im not replacing the pitman arm i was just referring to the torque from the pitman arm to the center link

 

Hey guys this link has the 88 Firebird manual that has the torque info and lots more!

Link still seems to work if not LMK.

https://www.thirdgen.org/forums/tech...ce-manual.html

 

torque specs: Got them from the Haynes Manual. I have them memorized as I just came out of the garage finishing mine up..

Center Link to Inner tie Rod End 50 ft lbs.
Spindle to Outer Tie Rod End 35 ft lbs
Center Link to Inner Tie Rod End 50 ft lbs... per Moog

 

Thanks a million going to put it together this evening