L05 ECM retarding timing
Thread Starter
Junior Member
iTrader: (2)
Joined: Oct 2005
Posts: 42
Likes: 0
From: S.W. Washington
Car: 1993 Caprice Classic "Woodie"
Engine: 350 TBI W/EBL Flash
Transmission: 4L60 S10 converter
Axle/Gears: 8.5, Torsen T2, 3.73s
L05 ECM retarding timing
Hi guys,
Stock internals, headers and exhaust 1993 L05 in my Caprice.
The car has been running like Cr@p, did all the tune up stuff, no Joy.
checked timing, it was correct at 0 W/spark control unplugged.
Then I reconnected, reved the motor and noticed that the spark was being retarded almost to the point that I couldn't see the mark! (timing mark moves almost back to the powers teering pump)
Prior to running poorly, I had to run high octane to keep from pinging.
What gives, Knock sensor?
Stock internals, headers and exhaust 1993 L05 in my Caprice.
The car has been running like Cr@p, did all the tune up stuff, no Joy.
checked timing, it was correct at 0 W/spark control unplugged.
Then I reconnected, reved the motor and noticed that the spark was being retarded almost to the point that I couldn't see the mark! (timing mark moves almost back to the powers teering pump)
Prior to running poorly, I had to run high octane to keep from pinging.
What gives, Knock sensor?
Thread Starter
Junior Member
iTrader: (2)
Joined: Oct 2005
Posts: 42
Likes: 0
From: S.W. Washington
Car: 1993 Caprice Classic "Woodie"
Engine: 350 TBI W/EBL Flash
Transmission: 4L60 S10 converter
Axle/Gears: 8.5, Torsen T2, 3.73s
Re: L05 ECM retarding timing
??????????????
Thread Starter
Junior Member
iTrader: (2)
Joined: Oct 2005
Posts: 42
Likes: 0
From: S.W. Washington
Car: 1993 Caprice Classic "Woodie"
Engine: 350 TBI W/EBL Flash
Transmission: 4L60 S10 converter
Axle/Gears: 8.5, Torsen T2, 3.73s
Re: L05 ECM retarding timing
HMMM,
used WINALDL to check it out and it shows 0 knock count from the knock sensors? Seems like it should be showing SOME knock.
Maybe it is a dead knock sensor, but why would if pull timing if it detects no knock?
I heard WINALDL may not fully support my '93 computer
used WINALDL to check it out and it shows 0 knock count from the knock sensors? Seems like it should be showing SOME knock.
Maybe it is a dead knock sensor, but why would if pull timing if it detects no knock?
I heard WINALDL may not fully support my '93 computer
Thread
Thread Starter
Forum
Replies
Last Post





