Are the accessory mounts the same on pre '87 heads and '87+ heads?
Thread Starter
Member
Joined: Nov 2000
Posts: 490
Likes: 0
From: E. Patchogue, NY
Car: '90 Iroc
Engine: 305 TPI
Transmission: 5 spd
Are the accessory mounts the same on pre '87 heads and '87+ heads?
Basically what is says, are the accessory mounts the same on both sets of heads? If so that would make the only differences the centerbolt and perimeter bolt valve cover setups and the angle of the middle bolts for the intake manifold right?
I want to know if I build a motor with the Stealth Ram could I get pre '87 heads and still mount my current serpentine accessory setup from my '90 motor? Thanks.
I want to know if I build a motor with the Stealth Ram could I get pre '87 heads and still mount my current serpentine accessory setup from my '90 motor? Thanks.
Supreme Member
Joined: Jul 1999
Posts: 5,183
Likes: 42
From: Oakdale, Ca
Car: 89 IrocZ
Engine: L98-ish
Transmission: 700R4
The actual accessories are differentt, but the bolt holes to mount them should be the same from the early '70's on up.
You're correct, 87 and some 86's, up up, use the newwer style angles...could be that the HSR is ready for both???? Not sure, by Accel Base works for either (Accel claims)
You're correct, 87 and some 86's, up up, use the newwer style angles...could be that the HSR is ready for both???? Not sure, by Accel Base works for either (Accel claims)
Supreme Member
iTrader: (2)
Joined: Jan 2002
Posts: 9,962
Likes: 5
From: Moorestown, NJ
Car: 88 Camaro SC
Engine: SFI'd 350
Transmission: TKO 500
Axle/Gears: 9-bolt w/ 3.23's
youll need to drill + tap one hole on the pass side head to accomodate the bracket. Otherwise, you good to go.
Thread
Thread Starter
Forum
Replies
Last Post
ambainb
Camaros for Sale
11
Apr 25, 2016 09:21 PM