Tech / General Engine Is your car making a strange sound or won't start? Thinking of adding power with a new combination? Need other technical information or engine specific advice? Don't see another board for your problem? Post it here!
Sponsored by:
Sponsored by: CARiD

Smooth Idle When It Warms Up Just Dies

Thread Tools
 
Search this Thread
 
Old Jun 16, 2003 | 09:25 AM
  #1  
cherryred89's Avatar
Thread Starter
Member
 
Joined: Jun 2003
Posts: 180
Likes: 0
From: Aurora Colorado
Car: 1989 camaro
Engine: 305c.i.d...... FOR NOW
Transmission: 700R4.....FOR NOW
Axle/Gears: 3.42 moser posi
Smooth Idle When It Warms Up Just Dies

Hey guys I have a 89 camaro RS with a 305 tbi the car runs great has good power but sometimes when its warm and sitting at idle it will all of the sudden just die but it will start right back up and run fine the idle speed is at 500 rpm that is spec for this car I've replaced the tps and the iac every sensor on this car is new plugs and wires are also new I've tried eveything but cant figure it out HELP!!!!!
Reply
Old Jun 16, 2003 | 10:21 AM
  #2  
Vader's Avatar
Moderator
25 Year Member
Liked
Loved
Community Favorite
 
Joined: Jan 2000
Posts: 19,655
Likes: 309
Idle speed is 500RPM? That's the idle speed to adjust the minimum air position of the throttle plates, but once the IAC is enabled, the target idle should be closer to 600-650 RPM in drive. Did I misunderstand your statement?
Reply
Old Jun 16, 2003 | 12:31 PM
  #3  
myz28u's Avatar
Junior Member
 
Joined: Feb 2003
Posts: 79
Likes: 0
Car: 91 Camaro RS
Engine: 305 TBI
Transmission: 700R4
I idle at like 400 in Drive and havent ever stalled.
Reply
Old Jun 16, 2003 | 12:49 PM
  #4  
dimented24x7's Avatar
Supreme Member
iTrader: (2)
 
Joined: Jan 2002
Posts: 9,962
Likes: 5
From: Moorestown, NJ
Car: 88 Camaro SC
Engine: SFI'd 350
Transmission: TKO 500
Axle/Gears: 9-bolt w/ 3.23's
the tbis have a really low idle speed. IIRC the base idle speed is like 450 rpms from the factory.
Reply
Old Jun 16, 2003 | 12:59 PM
  #5  
demonchild's Avatar
Senior Member
 
Joined: Aug 2002
Posts: 959
Likes: 0
From: So Cal
probably getting to hot around the tbi unit and vapor locking
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
GeneralIesrussi
Carburetors
6
Jun 20, 2024 07:21 PM
IROCtometal
TPI
2
Sep 20, 2015 11:08 PM
IROCtometal
TPI
3
Sep 9, 2015 10:01 AM
TBRays98
Tech / General Engine
6
Sep 6, 2015 05:05 PM
IROCtometal
TPI
0
Sep 2, 2015 02:01 PM




All times are GMT -5. The time now is 09:54 PM.