Cam Questions
Thread Starter
Member
Joined: Jun 2002
Posts: 491
Likes: 1
From: Hockessin, Delaware
Car: Red 91 RS Camaro
Engine: LO3 with Comp Cam
Transmission: 700R4
Axle/Gears: 4th gen rear
Cam Questions
I have a 91 RS with the LO3 V8 TBI engine, that I am rebuilding. Can someone give me the specs on the hydraulic roller cam that is in the engine and any recomendations on a nice cam with more HP and torque. I'm thinking one of crane cams powermax emissions legal cams.
Another question I think I mixed up the roller lifters in the engine, Is there anyway to find out which way they have to point cause i know they are angled to keep the cam in the enigne so I don't have to buy new ones.
Another question I think I mixed up the roller lifters in the engine, Is there anyway to find out which way they have to point cause i know they are angled to keep the cam in the enigne so I don't have to buy new ones.
Supreme Member
Joined: Apr 2001
Posts: 4,969
Likes: 0
From: USA
Car: yy wife, crazy.
Engine: 350, Vortecs, 650DP
Transmission: TH-350
Axle/Gears: 8.5", 3.42
The cam specs are at our homepage... www.thirdgen.org
Click on the link to the left titled "Tech Data"
Actually, here's a link..... https://www.thirdgen.org/newdesign/tech/techdb.shtml
The cam specs are toward the bottom of the page.
As far as what to use for a replacement; Search the TBI boards for the LT1 cam, or even the L98 cam.
I know where you can get an LT1 cam pretty cheap.
Psst ...... Look in my sig below.
Click on the link to the left titled "Tech Data"
Actually, here's a link..... https://www.thirdgen.org/newdesign/tech/techdb.shtml
The cam specs are toward the bottom of the page.
As far as what to use for a replacement; Search the TBI boards for the LT1 cam, or even the L98 cam.
I know where you can get an LT1 cam pretty cheap.
Psst ...... Look in my sig below.
Thread
Thread Starter
Forum
Replies
Last Post
