Where to get engine to trans bolts
Thread Starter
Supreme Member
iTrader: (2)
Joined: Nov 2000
Posts: 1,188
Likes: 2
From: Ft Worth, TX USA
Car: 2016 Ram 1500
Engine: 3.0L Diesel
Transmission: 8sp
Where to get engine to trans bolts
Took the trans off the car recently (700r4) and the engine to trans belhousing bolts turned out to be an improvized mix and match of bolts from ace hardware (scary).
I looked at summit and arp's website but I cant seem to find these listed anywhere. Am I just stupid and dont know what they are called or what. Where can I get a good set?
I looked at summit and arp's website but I cant seem to find these listed anywhere. Am I just stupid and dont know what they are called or what. Where can I get a good set?
Supreme Member
Joined: Mar 2002
Posts: 1,654
Likes: 2
From: Lower Salford, PA
Car: 1987 Camaro Z-28
Engine: 6.3L Victor EFI
Transmission: Tremec TKO 600
Axle/Gears: Moser 9"/4.11 Trac-Lok
The factory uses 3/8"-16x1-1/2" grade 5 bolts, nothing fancy. I used grade 8 in mine.
Thread Starter
Supreme Member
iTrader: (2)
Joined: Nov 2000
Posts: 1,188
Likes: 2
From: Ft Worth, TX USA
Car: 2016 Ram 1500
Engine: 3.0L Diesel
Transmission: 8sp
Ahh ok -- I saw those studs but wasnt sure if there might be a bolt replacement. Thanks for the slap on the back of the head.
Supreme Member
Joined: Mar 2002
Posts: 1,654
Likes: 2
From: Lower Salford, PA
Car: 1987 Camaro Z-28
Engine: 6.3L Victor EFI
Transmission: Tremec TKO 600
Axle/Gears: Moser 9"/4.11 Trac-Lok
After all the trans housing is cast aluminum. What's more likely to break cast aluminum or a steel bolt?
Thread
Thread Starter
Forum
Replies
Last Post
84z96L31vortec
Tech / General Engine
7
Aug 20, 2017 12:16 AM
84z96L31vortec
North East Region
1
Aug 10, 2015 08:27 PM