Tech / General Engine Is your car making a strange sound or won't start? Thinking of adding power with a new combination? Need other technical information or engine specific advice? Don't see another board for your problem? Post it here!
Sponsored by:
Sponsored by: CARiD

Is my oil pressure to HIGH

Thread Tools
 
Search this Thread
 
Old Jul 10, 2001 | 12:50 AM
  #1  
breathment's Avatar
Thread Starter
Supreme Member
 
Joined: Jun 2001
Posts: 3,175
Likes: 1
From: Bedford, Tx
Is my oil pressure to HIGH

I was reading that other post about oil pressure being to low, i thought i should ask about my oil pressure, NOw i know when u start the engine it will be high, but mine is past the 60 Mark, and remains like that till about 15 min later, then it will still run a little below 60 when actualy driving it, say 2000 RPMS or maybe more. IS that bad?

------------------
88' GTA 350 MODS---> air foil, K&N, Shift Kit, 180* therm, TB bypass
Reply
Old Jul 10, 2001 | 08:39 AM
  #2  
jcb999's Avatar
Supreme Member
 
Joined: Aug 1999
Posts: 1,443
Likes: 0
From: College Station, Tex USA
Car: 89rs
Engine: 400Sb
Transmission: Tremec 3550
Is this a new motor? did you go with a HV pump?

60 is not 2 high. The relief valve should be preventing any higher. What weight oil you running. What's it at when fully warm at ldle?
As long as your not blowing filters off or whipping to much air into it, ur ok.

Reply
Old Jul 10, 2001 | 09:05 AM
  #3  
Grand Prix's Avatar
Junior Member
 
Joined: Jun 2000
Posts: 55
Likes: 0
From: Newberry, FL
Not necessarily high volume, but high pressure. Melling makes three pumps for the small block that would generate 60+psi of oil pressure. Someone may have also changed the pressure regulator spring in the stock pump to a high pressure spring. If this has always been since you have owned the car (or engine) and its nice and steady don't worry. 60psi is good, better than a more stock 25-40psi.
Reply
Old Jul 10, 2001 | 10:18 AM
  #4  
Grim Reaper's Avatar
TGO Supporter
 
Joined: Jul 1999
Posts: 10,907
Likes: 4
From: The Bone Yard
Car: Death Mobile
Engine: 666 c.i.
Bad Oil Pressure Sensor. When they go, they do one of two things....don't read high enough...or read too high.
Reply
Old Jul 10, 2001 | 10:44 AM
  #5  
ATOMonkey's Avatar
Supreme Member
 
Joined: Jun 2001
Posts: 1,522
Likes: 0
From: Indianapolis IN
10 psi of pressure for every 1000 RPM is a good bench mark. My advice is to buy an aftermarket gauge if you're really worried.

------------------
'87 Bird 350 .060 over 700R4 + Lots more
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
89GTAOz
Tech / General Engine
13
May 16, 2020 09:31 AM
xxx3man`
Tech / General Engine
11
Sep 23, 2015 10:37 PM
355sbcTPI
Electronics
2
Aug 19, 2015 04:38 PM
bamaboy0323
Tech / General Engine
2
Aug 15, 2015 07:20 AM




All times are GMT -5. The time now is 10:03 PM.