IS THIS A GOOD MOTOR????!!!!
Thread Starter
Member
iTrader: (1)
Joined: Sep 2005
Posts: 312
Likes: 0
From: elverson pa
Car: 91 camaro
Engine: 383 stroker
Transmission: t5 :(
Axle/Gears: posi 373
IS THIS A GOOD MOTOR????!!!!
i want to build up a motor to put out between 400-500hp. found a block not far from my house for $75. its a mid 70's 350 2blt main and a 2 pieace rear main seal.just wanted to see ur input on it.
Supreme Member
iTrader: (1)
Joined: Jul 2004
Posts: 10,763
Likes: 4
From: Calgary, AB, Canada
Car: 1982 Trans-Am
Engine: 355 w/ ported 416s
Transmission: T10, hurst shifter
Axle/Gears: 10 bolt, true-trac, 3.73
that would be your basic run of the mill vanilla block. Nothing special, good or bad about it.
You can build it up to 500HP, it's all about what you put in it.
You can build it up to 500HP, it's all about what you put in it.
Supreme Member
Joined: Aug 2005
Posts: 3,004
Likes: 4
From: Yellowknife, NWT, Canada
Car: 84 Z28
Engine: 357
Transmission: TH-350C
Axle/Gears: 3.43
depends what condition the block is in.
It could be a junk block thats been cracked or it could be perfect and just need to be align honed and cleaned up!
It could be a junk block thats been cracked or it could be perfect and just need to be align honed and cleaned up!
Thread
Thread Starter
Forum
Replies
Last Post