Cam for tpi....
Thread Starter
Supreme Member
Joined: Apr 2002
Posts: 3,552
Likes: 5
From: New Jersey
Car: 86 Corvette, 89 IROC, 1999 TA
Engine: 350, 350, LS1
Transmission: 700r4, 700r4, T-56
Axle/Gears: 3.07, 373, 4.10
Cam for tpi....
Need a cam to work well with a factory tpi setup and prom.. I'd prefer something more aggressive than stock.. I'm looking for something cheap like a summit grind.. Anyone have a suggestion or two?
Supreme Member
iTrader: (1)
Joined: Jul 2004
Posts: 10,763
Likes: 4
From: Calgary, AB, Canada
Car: 1982 Trans-Am
Engine: 355 w/ ported 416s
Transmission: T10, hurst shifter
Axle/Gears: 10 bolt, true-trac, 3.73
Yea, don't use a summit grind.
Factory TPI setup - I'm 90% sure that's a roller cam, so I don't think a summit grind would even work. (unless you're talking about your vette...)
Cheap? LT1 takout cam is your answer. It's a common upgrade for your application, and for good reason.
Factory TPI setup - I'm 90% sure that's a roller cam, so I don't think a summit grind would even work. (unless you're talking about your vette...)
Cheap? LT1 takout cam is your answer. It's a common upgrade for your application, and for good reason.
Thread Starter
Supreme Member
Joined: Apr 2002
Posts: 3,552
Likes: 5
From: New Jersey
Car: 86 Corvette, 89 IROC, 1999 TA
Engine: 350, 350, LS1
Transmission: 700r4, 700r4, T-56
Axle/Gears: 3.07, 373, 4.10
Factory TPI setup.. block is a 72 or so 350 2 piece rms w/flat a tappet cam. LT1 cam would be a roller cam AFAIK... Need a cheap flat tappet cam.. 
Thread
Thread Starter
Forum
Replies
Last Post