Tech / General Engine Is your car making a strange sound or won't start? Thinking of adding power with a new combination? Need other technical information or engine specific advice? Don't see another board for your problem? Post it here!
Sponsored by:
Sponsored by: CARiD

Can't get a spark to fire the engine on a 89 camaro help please stumped....

Thread Tools
 
Search this Thread
 
Old May 23, 2007 | 09:16 PM
  #1  
redline86's Avatar
Thread Starter
Junior Member
 
Joined: May 2007
Posts: 64
Likes: 0
Can't get a spark to fire the engine on a 89 camaro help please stumped....

I put a new coil in just today and tried to start it and i'm still getting no spark the wires are fairly new. . Its got a 350 in it any help would be greatly appreciated....
Thanks,
Tim
Reply
Old May 23, 2007 | 10:54 PM
  #2  
77monte's Avatar
Junior Member
 
Joined: Jun 2006
Posts: 39
Likes: 0
From: Phoenix
Car: 77 Monte Carlo, 89 Firebird Formula
Engine: 355's
Transmission: TH350's
Axle/Gears: 10 bolt 8.5 3.73, 9 bolt 3.27
Re: Can't get a spark to fire the engine on a 89 camaro help please stumped....

First did you put the coil in to solve the no start problem? More information on the engine might be helpful. Is there Bat power to the distributor? if yes there isn't much past that point that it can be.. take the ignition module out and have it tested.. Rotor is in good condition with cap? no small cracks or trails in side the cap? Not much else i can say except this distributor was pulled out and put back in was it? Then maybe it could be not lining up correctly...
Reply
Old May 23, 2007 | 11:35 PM
  #3  
redline86's Avatar
Thread Starter
Junior Member
 
Joined: May 2007
Posts: 64
Likes: 0
Re: Can't get a spark to fire the engine on a 89 camaro help please stumped....

I only know that its a 350 according to the 8th number of the VIN and the carfax report says that as well. It is supposed to be bored over 30 as well but i'm not sure becuase we haven't taken the engine apart to know for sure or not. I just bought the car for 650 and it hasn't ran for like 2-5 months some time through there as far as i know. It has a brand new starter. haven't checked the ignition module yet didn't figure that would have anything to do with it getting spark or not becuase we did the old spark test of taking the first plug out and putting it on the engine to see if it sparks or not. And it didn't..When i turn it the egine turns but don't start... Maybe that will help you a little bit more.
Reply
Old May 23, 2007 | 11:37 PM
  #4  
redline86's Avatar
Thread Starter
Junior Member
 
Joined: May 2007
Posts: 64
Likes: 0
Re: Can't get a spark to fire the engine on a 89 camaro help please stumped....

oh almost forgot we replaced the distributor becuase they had it 180 degrees backwards and it messed up at the very bottom of it becuase of this.
Reply
Old May 24, 2007 | 06:53 PM
  #5  
iroczracer07's Avatar
Senior Member
15 Year Member
iTrader: (2)
 
Joined: Jun 2005
Posts: 813
Likes: 0
From: Adrian, Mi
Car: 1989 Camaro
Engine: 350 but it's torn down right now.
Transmission: 700r4
Axle/Gears: I'm working on it,lol.
Re: Can't get a spark to fire the engine on a 89 camaro help please stumped....

Pull a valve cover and see if the rockers are moving, which would indicate the cam is moving. The pull the capr off the distributor and see if the rotor is turning, which would indicate the cam and distributor are meshed properly. If all this is true, change the ignition module. Also make sure the wires going into the distributor are frayed or broken, and if you have an in cap coil make sure you didn't leave out the ground bar. I know that's not what it's called, but I can't think of the proper term at the moment.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
92camaroJoe
TBI
32
Jul 29, 2023 07:57 PM
InfinityShade
Transmissions and Drivetrain
15
Aug 22, 2015 08:00 PM
92camaroJoe
Tech / General Engine
6
Aug 13, 2015 06:07 AM
bradleydeanuhl
DFI and ECM
4
Aug 12, 2015 11:48 AM
djmarch
Tech / General Engine
5
Aug 9, 2015 05:27 PM




All times are GMT -5. The time now is 06:56 AM.