How far does a pressed in stud go into the boss?
Thread Starter
Supreme Member
iTrader: (2)
Joined: Jan 2002
Posts: 9,962
Likes: 5
From: Moorestown, NJ
Car: 88 Camaro SC
Engine: SFI'd 350
Transmission: TKO 500
Axle/Gears: 9-bolt w/ 3.23's
How far does a pressed in stud go into the boss?
I have to pin the pressed-in studs on my heads, but even with a 90 deg. drill adapter, I still wont be able to get them in straight. Ill have to angle them and I want to make sure the pin will actually intersect the entire stud. How far in does it go?
Last edited by dimented24x7; Aug 31, 2007 at 09:21 AM.
Supreme Member
iTrader: (1)
Joined: Jul 2004
Posts: 10,763
Likes: 4
From: Calgary, AB, Canada
Car: 1982 Trans-Am
Engine: 355 w/ ported 416s
Transmission: T10, hurst shifter
Axle/Gears: 10 bolt, true-trac, 3.73
Re: How far does a pressed in stud go into the boss?
About 5/8" or so.
Thread
Thread Starter
Forum
Replies
Last Post
New2Chevy
Engine/Drivetrain/Suspension Parts for Sale
2
Sep 28, 2015 12:35 AM
355tpipickup
Tech / General Engine
9
Sep 13, 2015 11:35 PM
