Stainless Steel motor mount through bolts?
Thread Starter
Supreme Member
iTrader: (45)
Joined: Dec 2003
Posts: 3,970
Likes: 1
From: Northern, VA
Car: Pair of 92 Z28s
Stainless Steel motor mount through bolts?
I like all new hardware, especially if its stainless steel. Anyway i got some of these from summit and they are about 1" too short...kinda pissed about that.
Other then just new bolts from the dealer anyone else know where to get some new stainless steel bolts made for the mount mounts?
http://store.summitracing.com/partde...5&autoview=sku
Other then just new bolts from the dealer anyone else know where to get some new stainless steel bolts made for the mount mounts?
http://store.summitracing.com/partde...5&autoview=sku
Senior Member
iTrader: (-1)
Joined: Mar 2007
Posts: 315
Likes: 0
From: Hobart, Indiana
Car: 1986 caged out firebird
Engine: 454 = wheelies
Transmission: th400 stall and trans brake
Axle/Gears: 4:11 ford 9" with ladder bars
Re: Stainless Steel motor mount through bolts?
i got my stainless steel bolts from ace hardware + they carry sizes up to like 6" so that would be good for a motor mount.. hope that helps
Joined: Feb 2002
Posts: 3,462
Likes: 4
From: N. Illinois
Car: 92 GTA/ 00 TA
Engine: 383/350
Transmission: 700R4/T-56
Re: Stainless Steel motor mount through bolts?
Don't forget about the hardness rating. I believe that 10.9 is the stock rating. Some stainless comes in grade 5 and other stainless comes in grade 8. I had to go to a specialty bolt store to get new motor mount through bolts. Even then all I could get was gold washed zinc grade 8 bolts.
Joined: Aug 2006
Posts: 12,812
Likes: 109
From: Central NJ
Car: 86 Trans Am
Engine: 408 stroker sbc
Transmission: TKO600
Axle/Gears: Moser full floater m9, 3:70 trutrac
Senior Member
iTrader: (-1)
Joined: Mar 2007
Posts: 315
Likes: 0
From: Hobart, Indiana
Car: 1986 caged out firebird
Engine: 454 = wheelies
Transmission: th400 stall and trans brake
Axle/Gears: 4:11 ford 9" with ladder bars
Re: Stainless Steel motor mount through bolts?
they have been holding up on my engine for a while i use them for the threw bolt in the mount that bolts the engine mount to the chassis mount also i am using them to bolt the chassis engine mount to the chassis
Thread
Thread Starter
Forum
Replies
Last Post
Terrell351
Engine/Drivetrain/Suspension Parts for Sale
5
Jun 13, 2021 01:13 PM
NBrehm
Engine/Drivetrain/Suspension Parts for Sale
0
Aug 5, 2015 07:57 PM
