kick out starter bendix?
Thread Starter
Supreme Member
iTrader: (1)
Joined: Jul 2004
Posts: 10,763
Likes: 4
From: Calgary, AB, Canada
Car: 1982 Trans-Am
Engine: 355 w/ ported 416s
Transmission: T10, hurst shifter
Axle/Gears: 10 bolt, true-trac, 3.73
kick out starter bendix?
My engine is on the stand now. I want to see if my starter is aligned right.
How do I hotwire the starter to just get it to kick out the bendix but not turn over?
I have a big stud for power
and two small studs for ?!???.
I've done this before but I can't for the life of me remember which one I had to jumper.
Thanks
How do I hotwire the starter to just get it to kick out the bendix but not turn over?
I have a big stud for power
and two small studs for ?!???.
I've done this before but I can't for the life of me remember which one I had to jumper.
Thanks
Supreme Member
Joined: Oct 2006
Posts: 1,974
Likes: 0
Car: 91 RS
Engine: 350 vortec
Transmission: T-5
Axle/Gears: not the best not the worst
Re: kick out starter bendix?
i think it is the one closest to the oil pan... but it will be an interesting if you guess wrong
Thread Starter
Supreme Member
iTrader: (1)
Joined: Jul 2004
Posts: 10,763
Likes: 4
From: Calgary, AB, Canada
Car: 1982 Trans-Am
Engine: 355 w/ ported 416s
Transmission: T10, hurst shifter
Axle/Gears: 10 bolt, true-trac, 3.73
Re: kick out starter bendix?
I'm just using my 10A battery charger, so it doesn't have enough snap to do too much damage. I'm hooking negative to the block, then setting power on each one.
None seemed to kick out the bendix.... I'll try that one again here..
None seemed to kick out the bendix.... I'll try that one again here..
Thread Starter
Supreme Member
iTrader: (1)
Joined: Jul 2004
Posts: 10,763
Likes: 4
From: Calgary, AB, Canada
Car: 1982 Trans-Am
Engine: 355 w/ ported 416s
Transmission: T10, hurst shifter
Axle/Gears: 10 bolt, true-trac, 3.73
Re: kick out starter bendix?
yea.... we'll call that plan B 
Thread
Thread Starter
Forum
Replies
Last Post
Gunner242
Electronics
7
Dec 25, 2015 04:49 PM
