pushrod length
Thread Starter
Member
Joined: Jun 2008
Posts: 165
Likes: 0
From: Moore, OKlahoma
Car: 86 WS6 Firebird
Engine: 355
Transmission: 700R4
Axle/Gears: 2.73 open
pushrod length
i have a 92 trans am with 305 tpi i have some 327 camaro double hump heads that are all original. i want to install with an intake and carb my question is will the stock pushrods work with the new heads. or will i have to buy new pushrods?
Moderator
Joined: Jul 1999
Posts: 17,268
Likes: 169
From: 51°N 114°W, 3500'
Car: 87 IROC L98
Engine: 588 Alcohol BBC
Transmission: Powerglide
Axle/Gears: Ford 9"/31 spline spool/4.86
Re: pushrod length
For the most part, stock pushrods will work but proper valve train geometry should always be checked when mixing and matching parts.
Supreme Member
Joined: Jul 2005
Posts: 1,675
Likes: 3
From: Arab, Alabama
Car: 1988 Trans Am GTA
Engine: 350 4BBL
Transmission: 700R4
Axle/Gears: 3.27
Re: pushrod length
Same heads I'm running on my 350. Don't forget the lead substitute with every fillup or you'll eat up the valve seats...
Thread
Thread Starter
Forum
Replies
Last Post
wigmobile
Electronics
5
Feb 26, 2025 02:56 PM
