How to tell if I have a 2 piece or 1 piece rear seal?
Thread Starter
Member
iTrader: (3)
Joined: Nov 2006
Posts: 140
Likes: 0
From: Tescott, Kansas 67484
Car: 1987 Camaro
Engine: 350 dart ies comp cam intake carb
Transmission: 700 r4, shift kit, 2400 stall
Axle/Gears: 10 bolt stock
How to tell if I have a 2 piece or 1 piece rear seal?
Hey,
Well I found a donor for a 6 speed swap for my car, it is an lt1 car and I want to make sure I don't need that expensive flywheel. From searches I have found that they changed styles around 86? My car is an 87 but I have no way of telling when the motor was made, its converted to carb. I can tell you it has a short water pump on it, and I put crane roller rockers on it. If either of that helps, I don't want to tear into in to find out lol.
Well I found a donor for a 6 speed swap for my car, it is an lt1 car and I want to make sure I don't need that expensive flywheel. From searches I have found that they changed styles around 86? My car is an 87 but I have no way of telling when the motor was made, its converted to carb. I can tell you it has a short water pump on it, and I put crane roller rockers on it. If either of that helps, I don't want to tear into in to find out lol.
Member
Joined: Aug 2007
Posts: 200
Likes: 0
From: Goldsboro, NC
Car: 82 camaro sc
Engine: 355 SBC
Transmission: T56
Axle/Gears: ford 8.8 3.73
Re: How to tell if I have a 2 piece or 1 piece rear seal?
all i can tell yo uis that 87 and up blocks are 1 pc rear mains. you will have to check the casting number on the block.
Thread Starter
Member
iTrader: (3)
Joined: Nov 2006
Posts: 140
Likes: 0
From: Tescott, Kansas 67484
Car: 1987 Camaro
Engine: 350 dart ies comp cam intake carb
Transmission: 700 r4, shift kit, 2400 stall
Axle/Gears: 10 bolt stock
Re: How to tell if I have a 2 piece or 1 piece rear seal?
ok thanks, ill have to get under there and have a look, maybe take a picture just to be sure...
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
May 10, 2023 07:19 PM
