Will these 1.6 rr work for me?
Thread Starter
Senior Member
iTrader: (1)
Joined: Feb 2008
Posts: 805
Likes: 0
From: Waynesville ohio
Car: 1986 corvette Z51
Engine: L98
Transmission: doug nash 4+3 speed
Axle/Gears: 3:42 posi
Will these 1.6 rr work for me?
Hey guys i have a 96 impala ss LT1 with iron heads then im putting a .540 in lift cam. So will these work or no?
http://detroit.craigslist.org/pts/1119906460.html
thanks
kevin
http://detroit.craigslist.org/pts/1119906460.html
thanks
kevin
Supreme Member
iTrader: (2)
Joined: Jan 2003
Posts: 1,083
Likes: 0
From: Northwestern Pennsylvania
Car: 1985 Pontiac Trans Am
Engine: 355 with stuffs.
Transmission: 700R4
Axle/Gears: 4.10 Posi
Re: Will these 1.6 rr work for me?
Without getting too lengthy... you may need to change your pushrods so your valvetrain geometry is correct. I can't recall if the LT1 uses 1.6 ratio stock or not. Do you have valve springs to match the new cam?
Thread
Thread Starter
Forum
Replies
Last Post
