pretty sure i tried it all what else can i do?
Thread Starter
Member

Joined: Sep 2007
Posts: 340
Likes: 0
From: bremerton
Car: 87 trans am
Engine: 5.7
Transmission: t-5
Axle/Gears: 9 bolt posi 3:27
pretty sure i tried it all what else can i do?
ok so my valves have been lashed correctly i tried a distributor advance kit. i tryied timing it all over the place. so in the attached file you can here the noise my engine is making. im driving uphill going about 25mph and im not hitting the gas hard just moderate. any suggestions on why my engine is making this noise you can clearly hear. you can also see that the rpms dont go above 2k and stay around there. and you can tell when i ease off the gas and push the pedal back down.
Senior Member
iTrader: (1)
Joined: Jul 2007
Posts: 1,141
Likes: 2
From: MA
Car: '87 IROC/'68 SS
Engine: 5.7L/350
Transmission: 700R4/Muncie 4-spd
Axle/Gears: 3.27 9 bolt / 3.31 12 bolt
Re: pretty sure i tried it all what else can i do?
Sounds like an exhaust leak in the audio file, but a cracked flex plate is pretty common and will drive you crazy.
Thread Starter
Member

Joined: Sep 2007
Posts: 340
Likes: 0
From: bremerton
Car: 87 trans am
Engine: 5.7
Transmission: t-5
Axle/Gears: 9 bolt posi 3:27
Re: pretty sure i tried it all what else can i do?
exhaust leak you say. alright i'll get under there today after it cools down and check it out. thanks. if that doesnt work i guess i'll try higher octane fuel
Thread Starter
Member

Joined: Sep 2007
Posts: 340
Likes: 0
From: bremerton
Car: 87 trans am
Engine: 5.7
Transmission: t-5
Axle/Gears: 9 bolt posi 3:27
Re: pretty sure i tried it all what else can i do?
well i checked for loose bolts on the header and i was able to turn 5 of them by hand. so i tightened them down and low and behold. no more noise. ever seen that commercial that states when your car is running well you can feel it. yeah i can feel it
Senior Member
iTrader: (1)
Joined: Jul 2007
Posts: 1,141
Likes: 2
From: MA
Car: '87 IROC/'68 SS
Engine: 5.7L/350
Transmission: 700R4/Muncie 4-spd
Axle/Gears: 3.27 9 bolt / 3.31 12 bolt
Re: pretty sure i tried it all what else can i do?
Glad you found it and it was a simple fix.
Thread
Thread Starter
Forum
Replies
Last Post
Elephantismo
Electronics
14
Feb 13, 2019 12:51 AM
ramicio
Engine/Drivetrain/Suspension Wanted
3
Sep 28, 2015 01:18 PM





