CAR wont start!! getting power to coil
CAR wont start!! getting power to coil
ok so i'm lost i have bypassed the VATS bought a new ignition switch,neutral saftey switch and coil i get power to the coil when the key is on but no spark from the coilwhen i turn it over. what's going on ??
Supreme Member
Joined: Mar 2008
Posts: 1,549
Likes: 1
From: CT
Car: 86 T/A, 83 Z/28
Engine: 5.0 TPI, 350 2 X 4 bbl
Transmission: 4 speed auto, 5 speed manual
Axle/Gears: 3.23 posi, 3.73 std
Re: CAR wont start!! getting power to coil
First off as i always have to ask how do you know your not getting any spark? Assuming for a moment thats true though check your grounds (the ones inside the distributor too) and check your ignition module.
Senior Member
iTrader: (1)
Joined: Jul 2006
Posts: 506
Likes: 1
Car: 1989 GTA
Engine: 350TPI w/ Speed Density
Transmission: 700r4
Axle/Gears: Borg warner 3.27
Re: CAR wont start!! getting power to coil
It's not the neutral safety switch, the car wont even turn over if that's tripped. I don't believe it has anything to do with VATS because I believe that only prevents injector pulses (correct me if I'm wrong). If you have any way of datalogging, or just using tunerpro's diagnostics, that would make your job easier. Test your dist. reference coil (the coil wrapped around the distributor shaft with one yellow and one green wire connected, yellow and green wires plug into the back of ignition module)
Thread
Thread Starter
Forum
Replies
Last Post





