freeze plug problem
Thread Starter
Junior Member
iTrader: (3)
Joined: Feb 2008
Posts: 31
Likes: 0
From: Las Vegas
Car: 88 Iroc-Z Convertible
Engine: 350 TPI
Transmission: 700r4
Axle/Gears: 3.27
freeze plug problem
today i was replacing the freeze plug on my camaro and my dumb a$$ hammered it through the whole were it goes now i cant get it out
is there any who CAN PLEASE HELP ME !!!!!
is there any who CAN PLEASE HELP ME !!!!!
Junior Member
Joined: Aug 2009
Posts: 97
Likes: 1
Re: freeze plug problem
Haha, my Ford mechanic brother did the same thing when we were rebuilding a 350. We had to drill a little hole in the plug and through the use of a pair of needle nose pliers, a screw and slide hammer we were able to get it out.
Joined: Aug 2009
Posts: 2,102
Likes: 8
From: Clinton Township, Michigan
Car: 91 GTA, 73 Z28
Engine: 355, 6.0L
Transmission: TH350, 4L80E
Axle/Gears: 3.42, 3.73
Re: freeze plug problem
yeah just smush it with a pair of pliers and pul it out, buy a new one, and put that one in, not too difficult, and i doubt you hurt the block
Thread
Thread Starter
Forum
Replies
Last Post
