Would this work?
Thread Starter
Member
iTrader: (3)
Joined: Apr 2009
Posts: 249
Likes: 0
From: D Heights, Mi
Car: 1989 Camaro
Engine: Sbc 355
Transmission: TH350
Axle/Gears: 3.42 Detroit locker
Would this work?
Would this be a good cam for a 305?
http://www.summitracing.com/parts/LU...e%7c5.0L%2f305
It is a Hydraulic Roller Tappet, Advertised Duration 284/284, Lift .492/.492, Chevy, Small Block, Each lca of 112
If so would this give a loopy idle? If not, then suggestions are welcome. Would like a little lopy sound too if possible.
http://www.summitracing.com/parts/LU...e%7c5.0L%2f305
It is a Hydraulic Roller Tappet, Advertised Duration 284/284, Lift .492/.492, Chevy, Small Block, Each lca of 112
If so would this give a loopy idle? If not, then suggestions are welcome. Would like a little lopy sound too if possible.
Thread Starter
Member
iTrader: (3)
Joined: Apr 2009
Posts: 249
Likes: 0
From: D Heights, Mi
Car: 1989 Camaro
Engine: Sbc 355
Transmission: TH350
Axle/Gears: 3.42 Detroit locker
Re: Would this work?
ok Ive seen a max lift of .480 for stock heads. That right? if so then what duration would be good and lca? Not looking to do the same ol lt1 hot cam..
Thread
Thread Starter
Forum
Replies
Last Post
Terrell351
Engine/Drivetrain/Suspension Parts for Sale
5
Jun 13, 2021 01:13 PM
