I'll just get to the point. Car won't start. I am getting spark to the to the ignition coil when my engine turns over but doesn't fire. I replaced my coil and cap and wires. But yesterday I took out my spark plugs and I am not getting spark to the Spark Plugs. I am getting fuel and air, just no spark. I bypassed vats also. This holding my project back. I don't want to give in and just get an aftermarket setup because saving money is key for me. So any info will help and I always get good feedback from ThirdGen.

 

how are you checking for spark a 4okv tester ?

 

Volt meter and looking for a spark with the plug out of the block but hooked up to the distributor.

 

replace ur igntion module its under your distributer cap and has to electrical connections form the side of it ,costs about forty dollars and change easy install

 

I went to get it tested and it past. I'm actually working on it now. I'm out of ideas