Tech / General Engine Is your car making a strange sound or won't start? Thinking of adding power with a new combination? Need other technical information or engine specific advice? Don't see another board for your problem? Post it here!
Sponsored by:
Sponsored by: CARiD

Random Starter/Ignition problem

Thread Tools
 
Search this Thread
 
Old May 1, 2013 | 05:14 PM
  #1  
bigchief's Avatar
Thread Starter
Senior Member
 
Joined: Jun 2004
Posts: 741
Likes: 1
From: Long Island NY
Car: 1989 Firebird Formula
Engine: 5.7L 355 TPI
Transmission: 700 R4 with TCI rebuild kit and valve body mods
Random Starter/Ignition problem

It seems as if my car will not turn over, at random....

1989 Firebird Formula, TPI

It has happened when the car is cold, warm, sitting for a long time or just recently driven.

I hear a *click* (as usual) when i put the key in the ON position, then when i turn to crank, nothing happens.

I try again a half hour later, and it works just fine.

Note: This problem has been happening for YEARS, and yes, i have tried replacing the starter
Reply
Old May 19, 2013 | 02:22 PM
  #2  
FNFAL308's Avatar
Member
iTrader: (1)
 
Joined: Feb 2007
Posts: 489
Likes: 0
From: Spring, TX
Car: 91 Bird
Engine: TPI 350
Transmission: 5-Speed
Axle/Gears: 2.77 posi
Re: Random Starter/Ignition problem

Mine just started doing this. Changed the starter no difference.

I hear the click every time. Sometimes it starts first time, some second time, sometimes after 5 clicks.
Reply
Old May 19, 2013 | 02:25 PM
  #3  
FtrSpeedy's Avatar
Member
 
Joined: Mar 2012
Posts: 323
Likes: 1
From: Iowa
Car: 14 scion tc/91 camaro rs
Engine: 2.5/ 360 pooch
Transmission: 6spd man/th350
Axle/Gears: na/2.73
Re: Random Starter/Ignition problem

Tried changing ignition switch?
Reply
Old May 19, 2013 | 06:41 PM
  #4  
FNFAL308's Avatar
Member
iTrader: (1)
 
Joined: Feb 2007
Posts: 489
Likes: 0
From: Spring, TX
Car: 91 Bird
Engine: TPI 350
Transmission: 5-Speed
Axle/Gears: 2.77 posi
Re: Random Starter/Ignition problem

After reading what others were saying I took the cables off again (had already done this). No rust, no corrosion, everything tight.

Sand papered the ends and the battery terminals (side posts). No problem now. Go figure.
Reply
Old May 20, 2013 | 05:25 PM
  #5  
FNFAL308's Avatar
Member
iTrader: (1)
 
Joined: Feb 2007
Posts: 489
Likes: 0
From: Spring, TX
Car: 91 Bird
Engine: TPI 350
Transmission: 5-Speed
Axle/Gears: 2.77 posi
Re: Random Starter/Ignition problem

That gremlin is back today. Ig switch is a good idea. Rarely change those so it didn't come to mind.
Reply
Old May 20, 2013 | 08:48 PM
  #6  
FNFAL308's Avatar
Member
iTrader: (1)
 
Joined: Feb 2007
Posts: 489
Likes: 0
From: Spring, TX
Car: 91 Bird
Engine: TPI 350
Transmission: 5-Speed
Axle/Gears: 2.77 posi
Re: Random Starter/Ignition problem

changed ignition starter switch and found that the key switch doesn't seem to move the rod to the switch as it should.

Have any of you seen this to wear out?

http://www.oreillyauto.com/site/c/de...gnition+switch
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
GeneralIesrussi
Carburetors
6
Jun 20, 2024 07:21 PM
andy74
Electronics
2
Sep 3, 2015 08:41 AM
GeneralIesrussi
Tech / General Engine
0
Sep 3, 2015 03:23 AM
Jackrabbit501
Electronics
1
Sep 2, 2015 09:14 PM
greenyone
TPI
3
Sep 2, 2015 03:39 PM




All times are GMT -5. The time now is 09:12 PM.