Adjusting the timing
Thread Starter
Junior Member
Joined: Jul 2007
Posts: 4
Likes: 0
Adjusting the timing
Hi.
I hope I can get the help of someone knowledgeable on this forum.
I need assistance with "stock" basic setting on timing on my car.
In the manual it says "Set timing according to instruction on emission control information label"
My decal is long gone.
I have been given advice on everything from 0 to 10 degrees btdc.
grateful for the links or the whole procedure step by step.
My car. 1987 Firebird Trans Am GTA. L98. 5, 7 l 350 TPI.
Håkan SWEDEN
I hope I can get the help of someone knowledgeable on this forum.
I need assistance with "stock" basic setting on timing on my car.
In the manual it says "Set timing according to instruction on emission control information label"
My decal is long gone.
I have been given advice on everything from 0 to 10 degrees btdc.
grateful for the links or the whole procedure step by step.
My car. 1987 Firebird Trans Am GTA. L98. 5, 7 l 350 TPI.
Håkan SWEDEN
Joined: Dec 2004
Posts: 16,694
Likes: 979
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: Adjusting the timing
https://www.thirdgen.org/forums/tpi/...-question.html
The timing should be set to 6 dbtdc when the engine is warm and esc disconnected.
The timing should be set to 6 dbtdc when the engine is warm and esc disconnected.
Thread
Thread Starter
Forum
Replies
Last Post
