Car cranks but no start
Car cranks but no start
91 Formula 305 tbi.. Sat for a month. Went to start and nothing but cranking.
New ignition control module and ignition coil, plus a new fuel pump relay.
Motor cranks, but doesnt start. I see no fuel spray from injectors and with starting fluid, nothing.
What should i do next? Car ran just fine a few weeks ago !!!
New ignition control module and ignition coil, plus a new fuel pump relay.
Motor cranks, but doesnt start. I see no fuel spray from injectors and with starting fluid, nothing.
What should i do next? Car ran just fine a few weeks ago !!!
Member
Joined: Apr 2012
Posts: 139
Likes: 0
From: Philadelphia,Pa
Car: 1991 Pontiac Trans Am
Engine: 305 TPI
Transmission: 700R4
Axle/Gears: 3:42
Re: Car cranks but no start
Is there spark? A check engine light? If both spark and fuel are out I'd assume a bad ecm or a bad connection somewhere.
Member
Joined: Mar 2012
Posts: 117
Likes: 0
From: New York
Car: 1985 IROC-Z H.O. 4bbl
Engine: L69 Small-Block, 305
Transmission: Borg-Warner T5
Axle/Gears: 3.73
Re: Car cranks but no start
Have you checked if you got spark? .. if not, then I would stab me a screw driver in 1 of the spark plug wires and have some one turn the engine over. if you get shocked then. yeah you know the deal.
Re: Car cranks but no start
Havent checked spark since replacing ignition control module and coil . I thought replacing that would do it. Not even so much as a start with starting fluid and new parts. Hope I dont have to drop tank for new pump and sending unit.
Member
Joined: Mar 2012
Posts: 117
Likes: 0
From: New York
Car: 1985 IROC-Z H.O. 4bbl
Engine: L69 Small-Block, 305
Transmission: Borg-Warner T5
Axle/Gears: 3.73
Re: Car cranks but no start
nope. you know. you could just need a tune up. (plugs,roter, wires)... if you said you tried using started fluid and it didn't even make a stutter to try and start then it aint fuel.
Trending Topics
Joined: Apr 2005
Posts: 7,736
Likes: 14
From: Not in Kansas anymore
Car: 82 Z28
Engine: 383 SP EFI/ 4150 TB
Transmission: T400
Axle/Gears: QP 9" 3.73
Re: Car cranks but no start
You may have screwed something up when replacing parts or got faulty parts.( not uncommon these days )
That is the big indication you have NO SPARK in the clylinder
A Ign system diagnostic work through like this can help identify where you have a problem
Read all 6 pages of tests
http://easyautodiagnostics.com/gm_ic...n_module_1.php
Thread
Thread Starter
Forum
Replies
Last Post






