final build.... Really. thoughts?
Thread Starter
Member
iTrader: (2)
Joined: Jun 2006
Posts: 122
Likes: 0
From: Rocky Face, Ga
Car: 1989 Formula
Engine: 355ci HSR SBC
Transmission: 700r4
Axle/Gears: 3.27
final build.... Really. thoughts?
Here goes nothing. Finally got my profiler heads in today. They look great. I've spoken with a few of you on build ideas and have slowly narrowed it down over the months. Here are specs, I'd like a critique and your thoughts on what, if anything you would do to change it, and what you think it is capable of.
I originally had a cam that was a 214/218 with .488/.495 lift. I'm thinking of swapping it with a xfi268hr13. Thoughts?
HSR, 30# injectors, profiler 180cc w 64cc chambers, New stock lifters and crank, hypertucteic pistons, block .030 over. It will be tuned by tuned performance. Cam I'm thinking of switching to is above this paragraph. Oh, and how much of a difference will the new cam make?
Transmission should hold 650tq/hp. Converter is an edge 3000 stall.
When my stock rear breaks.... What should I replace it with, ratio wise? It has a stock formula 350/auto trans posi , rear ratio.
Anyone?
I originally had a cam that was a 214/218 with .488/.495 lift. I'm thinking of swapping it with a xfi268hr13. Thoughts?
HSR, 30# injectors, profiler 180cc w 64cc chambers, New stock lifters and crank, hypertucteic pistons, block .030 over. It will be tuned by tuned performance. Cam I'm thinking of switching to is above this paragraph. Oh, and how much of a difference will the new cam make?
Transmission should hold 650tq/hp. Converter is an edge 3000 stall.
When my stock rear breaks.... What should I replace it with, ratio wise? It has a stock formula 350/auto trans posi , rear ratio.
Anyone?
Last edited by truckerz; Jun 4, 2014 at 06:27 AM.
Thread
Thread Starter
Forum
Replies
Last Post