high lift cam+stock heads guys within
Thread Starter
Supreme Member
Joined: Nov 2001
Posts: 1,526
Likes: 0
From: Cleveland, OH
Car: '87 Camaro LT
Engine: 355 L98
Transmission: T56
high lift cam+stock heads guys within
how much did you get your valve guides milled, what heads were they on and what was the lift of the cam?
my L98 had its guides milled .050 for .492 lift. well i bent my pushrods and i'm wondering maybe they werent milled enough but i think my rods are just too weak.
my L98 had its guides milled .050 for .492 lift. well i bent my pushrods and i'm wondering maybe they werent milled enough but i think my rods are just too weak.
Supreme Member
Joined: Jul 1999
Posts: 18,457
Likes: 16
From: Loveland, OH, US
Car: 4
Engine: 6
Transmission: 5
186s... I'm running .545"/.555" in the motor in question, plus Teflon "positive" seals... can't tell you for sure how much they're milled... obviously I have real (NOT 1.25") valve springs, and real retainers. No problems.
Thread
Thread Starter
Forum
Replies
Last Post
