TPI Tuned Port Injection discussion and questions. LB9 and L98 tech, porting, tuning, and bolt-on aftermarket products.
Sponsored by:
Sponsored by:

No start condition, tried the usual suspects...

Thread Tools
 
Search this Thread
 
Old Jun 24, 2003 | 04:36 PM
  #1  
ES87iroc's Avatar
Thread Starter
Supreme Member
 
Joined: May 2001
Posts: 2,228
Likes: 2
From: Your neighbor's hood, MD
Car: 1987 Camaro Z28 IROC-Z
Engine: 5.7L TPI
Transmission: T5
Axle/Gears: 3.42:1
No start condition, tried the usual suspects...

Hey guys, I figured I would try in here and see if anyone had any ideas what is going on with my car.

On the way back from the nationals sunday my car is cruising along for about 30 minutes and just up and dies. No warning, just quits. I checked all the usual stuff, fuses, etc. I can hear the pump run when I turn the key on, I have tried so far:

dist module
ESC module
coil
coil wire
ECM
fuses
rewiring ecm power feed line
rotor
memcal
kicking it

Anyone have any ideas? Like I said, I can hear the pump run, the engine rolls over easy, just no startup. Is there a way of seeing wether the injectors pulse when trying to start? i was guessing that it would get +12v across the terminals intermittently, but no good. Also, there is NO spark coming from the coil when trying to start, either.

Help! :hail:
Reply
Old Jun 24, 2003 | 11:46 PM
  #2  
fisherbody86's Avatar
Member
 
Joined: Mar 2003
Posts: 406
Likes: 1
From: under the hood
Car: 92 Z28 heritage
Engine: 5.0 TPI
Transmission: T-5
Did you buy a napa ignition module, because those are bad right out of the box.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Infested
Tech / General Engine
3
May 22, 2018 11:56 PM
Caspar
TPI
24
Jun 19, 2016 11:19 PM
mdtoren
Tech / General Engine
0
Aug 16, 2015 05:45 PM




All times are GMT -5. The time now is 02:31 AM.