Delphi MAF
Thread Starter
Junior Member
Joined: Feb 2001
Posts: 19
Likes: 0
From: Connecticut
Delphi MAF
Does anyone have any experience with a delphi MAF , does anyone know the flow specs over stock? judging from the picture of the delphi it should flow much more that a stock maf. the part number im looking at is AF10012 its for 85-89 tpi maf systems, not sure of the cost, but if anyone has any feedback please dont hesitate to give your 2 cents
Thread Starter
Junior Member
Joined: Feb 2001
Posts: 19
Likes: 0
From: Connecticut
Supreme Member
iTrader: (2)
Joined: Jul 2001
Posts: 1,823
Likes: 1
From: San Antonio, TX
Car: 1988 IROC-Z
Engine: L98 (350 TPI)
Transmission: MD8 (700 R4) + 3.42 LS1 Rear
looks VERY similar to the Bosch design. hard to tell if any inprovements have been made without seeing the inside of the sensor. IE if the filment wire design is still being used.
Supreme Member
iTrader: (2)
Joined: Jul 2001
Posts: 1,823
Likes: 1
From: San Antonio, TX
Car: 1988 IROC-Z
Engine: L98 (350 TPI)
Transmission: MD8 (700 R4) + 3.42 LS1 Rear
ahh... looks just like the wells SU-145 MAF. similar hot film design. nice find not being a wells brand.
Trending Topics
Thread Starter
Junior Member
Joined: Feb 2001
Posts: 19
Likes: 0
From: Connecticut
how about performance
To me this looks like it will flow much better than stock, im still uneasy about taking the screens out and shavng the heat sink, anyone find any problems when they did theres? if so were you able to correct it by changing somthing in the prom?
Thread
Thread Starter
Forum
Replies
Last Post
BumpaD82
Tech / General Engine
37
Feb 26, 2016 02:57 PM
